Could you please send the script you used and the input structure to reproduce the problem?
Thank you for your reply.
I think that it would be better to send you the whole project as an example.
To reproduce the problem please launch the project attached. Then open Polymers -> Form view for Polymers.
Push "Surface area Calculator". Then refresh the form to see new Conformers generated (select another structure in Polymers block and then go back).
In the Surface area block for each Conformer (from Conformers block) there must be calculated ASA, ASA+ etc.. ASA and others fields should be different for different Conformers, but they are the same and are equal to the surface areas of a 3d cleaned molecule. I think that it is not a prescribed behavior.