wireframe mode

Hello





Is there any way to change the writing of the number following the hydrogen atoms? I'd like to make for example the "3" in "CH3" appears with same width than the letters.





By the way, I'm using Marvin Sketch 4.1.3.





Thanks for answering

Hello, the subscript/superscrip should be slightly smaller by default as the normal letters. Could you send us a picture what would you like - or what is that part that you do not like?

Thanks for answering that quick. What I'd like is exactly like that : CH3, NH2, etc. where the size of the numbers are the exact same one as the size of the letter. I know it shouldn't be this way, but it's the way I'd like it.





I know I can do it for example with the ChemSketch software... But for some reasons, I prefer using MarvinSketch. I'm just hoping I could do it too.





Thanks a lot for helping.

Place an alias to the proper atom. By usage of aliases, you can change the label of the atoms.


Push "More" button, type "CH3" or anybody else in the input field of the popup window, then push "alias" button. After then, go to the canvas and click to the proper atom to set this alias on it.